20-Watt Dimming LED Driver/12-Volt DC Power Supply
20-Watt Dimming LED Driver/12-Volt DC Power Supply – remove end caps to direct wire

20-Watt Dimming LED Driver
12-Volt DC Power Supply

$29.99

Armacost Lighting’s 20-Watt Dimming LED Lighting Driver provides the utmost in performance, reliability, economy and versatility. It uses an integrated microprocessor to automatically sense and optimize LED dimming performance based on the load and type of dimmer being used. This electronic, solid-state power supply is compatible with 120-volt AC dimmers.

The 20-watt power supply works equally well whether powering a single 1-watt LED puck light or 20 watts of tape lighting, or a combination of both. No minimum power load is required for effective, flicker-free dimming. Connect up to 100% of the rated 20-watt maximum load.

  • Smooth, full range flicker-free dimming, no “pop-on” or “drop-off” of lighting
  • Compatible with 120-volt AC dimmers and lighting controls
  • Suitable for use in dry locations
SKU: 820200 Category:

Product Description

  • For direct wire installations. Simply remove end caps to access on-board terminal block connectors; use NM 14AWG 2C cable (Romex® style) to tie in with 120-volt AC line voltage
  • Uses desirable soft start on and fade off technology
  • Connect up to 100% of the rated 20 watt maximum load – derating performance is not required
  • Class 2 power supply is intrinsically safe
  • NEC Class II AC input requires no ground wire connection
  • Safety features include automatic shut-off in case of lighting overload, open circuit, short circuit, over temperature or other fault; the unit will automatically restart after the fault is corrected
  • Limited 3-year warranty. Failure to use this power supply for its intended purpose or improper installation will void warranty.

Armacost Dimmable LED Drivers are compatible with both forward phase (leading edge, triac, incandescent) and reverse phase (electronic low voltage, ELV, and trailing edge) AC dimmers, including higher end lighting controls, such as Lutron GRAFIK Eye® systems.

Although virtually all dimmers will work with Armacost Dimmable LED Drivers, Armacost Lighting recommends dimmers that can be programmed or have an adjustment dial to set the low end dimming range, such as Lutron® C•L and Leviton IllumaTech® Universal Dimmers. These dimmers are readily available in stores and offered in a wide range of styles and colors.

Download Installation Guidelines

Specifications

  • No minimum lighting load required for wide range dimming
  • No de-rating is required; load up to 100% of the model’s rated capacity
  • Rated for 30,000 hours when used 8-12 hours a day at full load; expect longer life when dimmed or when using lesser wattage loads.
  • Full safety shut off protection in case of lighting overload, open circuit, short circuit, over-temperature, or other fault. The driver will automatically restart after the fault has been corrected.
  • Output: 12-volt DC constant voltage
  • Ta = -4° F (-20°C) to 122° F (50° C)
  • Class II AC input (two-wire connection, requires no ground)
  • Complies with FCC Part 15B
  • Safety Standards: UL Std. 1310 and 8750, Cert. to CAN/CSA Std. C22.2 No. 223-M91 and C22.2 No. 250.13; For dry location use only
  • Dimensions: 5-3/16 in. L x 1-3/4 in. W x 3/4 in. D (131.8mm L x 44.5mm W x 19.1mm D)
X