- For direct wire installations. Simply remove end caps to access on-board terminal block connectors; use NM 14AWG 2C cable (Romex® style) to tie in with 120-volt AC line voltage
- Uses desirable soft start on and fade off technology
- No minimum power load; dimming works equally well whether powering a single 3-watt LED puck light or 60 watts of tape lighting, or a combination of both
- Connect up to 100% of the rated 60-watt maximum load – derating performance is not required
- Class 2 power supply is intrinsically safe
- NEC Class II AC input requires no ground wire connection
- Safety features include automatic shut-off in case of lighting overload, open circuit, short circuit, over-temperature or other faults; the unit will automatically restart after the fault is corrected
- Limited 3-year warranty. Failure to use this power supply for its intended purpose or improper installation will void the warranty.
Armacost Dimmable LED Drivers are compatible with both forward phase (leading edge, triac, incandescent) and reverse phase (electronic low voltage, ELV, and trailing edge) AC dimmers, including higher-end lighting controls, such as Lutron GRAFIK Eye® systems. They are also compatible with low-voltage PWM dimmers and RGB color controllers.
Although virtually all dimmers will work with Armacost Dimmable LED Drivers, Armacost Lighting recommends dimmers that can be programmed or have an adjustment dial to set the low-end dimming range, such as Lutron® C•L and Leviton IllumaTech® Universal Dimmers. These dimmers are readily available in stores and offered in a wide range of styles and colors.
*Disconnect AC cord plug when using an AC dimmer. The National Electrical Code® (NEC) prohibits dimming lights that are connected to standard plug-in receptacle outlet (note that this does not apply to wireless plug-in “lamp dimmers”). Use direct wire installation method with an AC dimmer or use an Armacost Lighting low-voltage dimmer on the 12-volt side.